KaControl KNX - Kampmann

[intelligente Haustechnik]

KNX is master, you can the other controller omitting
set P54 of 1
the resistors must be connect on the mainboard

kampmann has a knxproj with small or full connection to modbus and a top german support

[zybi]

Hello
Does anyone have experience with KaControl KNX - Kampmann?
I have got few questions:
- is this connection correct?
- whether the 1 kOhm and 10 kOhm resistors should be connected only at the master - i.e. where the KNX card is or also on the other KaControl
- whether the setting from the P54 controller "1" should be only for the master or also for other slaves
- how the DIP switch (in KaControl Smartboard) should be set to master and how to slave.
Thanks for the help

Best regards
zybi