Hello all
(I’m Paulo/ Hobby KNX-Partner 9781)
In the first place I hope you had all a “Joyful Christmas” and I which you a “Happy New Year”.
Sorry to bother you. I have been searching the “KNX-User-Forum” but I have not been lucky with an answer to my issue.
I have built my EFH @4 years ago and installed a simple KNX system (ABB+Berker, with ETS3). Everything was successfully. 4 years later I had to replace an ABB actuator (new installation is working). But I decided to make an additional change.
I would like to replace an old function using ABB SA/S4.16.5S Switch (Channel D) + B.IQ Tastsensor 3fach Komfort (Taster D) by a new funciton ABB SA/S4.16.5S Switch (Channel D) + Berker Wächter 180° Komfort.
Please note: Both Taste and BWM are separated. Each has its BCU.
Know the issue:
I’m using same Group address. I have deleted the previous configuration ABB+B.IQ and linked now ABB+BWM. I have downloaded the application software for both components. Download process was successfully.
However, BWM is not working. Gehtest is not working. He is not detecting any motion. Curious, after downloading the new function (ABB+BWM) the old one is still working.
Did you ever experience this issue? Do you have any solution?
PS: I have replaced by other 'spare' BWM units (new ones). Same issue.
Thank you all for your time.
Regards,
Paulo
(I’m Paulo/ Hobby KNX-Partner 9781)
In the first place I hope you had all a “Joyful Christmas” and I which you a “Happy New Year”.
Sorry to bother you. I have been searching the “KNX-User-Forum” but I have not been lucky with an answer to my issue.
I have built my EFH @4 years ago and installed a simple KNX system (ABB+Berker, with ETS3). Everything was successfully. 4 years later I had to replace an ABB actuator (new installation is working). But I decided to make an additional change.
I would like to replace an old function using ABB SA/S4.16.5S Switch (Channel D) + B.IQ Tastsensor 3fach Komfort (Taster D) by a new funciton ABB SA/S4.16.5S Switch (Channel D) + Berker Wächter 180° Komfort.
Please note: Both Taste and BWM are separated. Each has its BCU.
Know the issue:
I’m using same Group address. I have deleted the previous configuration ABB+B.IQ and linked now ABB+BWM. I have downloaded the application software for both components. Download process was successfully.
However, BWM is not working. Gehtest is not working. He is not detecting any motion. Curious, after downloading the new function (ABB+BWM) the old one is still working.
Did you ever experience this issue? Do you have any solution?
PS: I have replaced by other 'spare' BWM units (new ones). Same issue.
Thank you all for your time.
Regards,
Paulo