[wiregate] Looking for 1-Wire probe housing

[martenss]

Hi,

I am looking for a housing box and/or cover plate to mount two 1-Wire probes outdoor. I will probably need an AP and UP variant.

For the UP one I have once seen a nice stainless steel plate with integrated probe, but fail to find it in a webshop now.

Note: I've got the probes already from the Wiregate shop.

Any examples / ideas?

Thanks and kind regards, martenss

[mkeil]

I've made these one by myself.
Just a piece of PVC-Pipe and a cover for a nut.
Assambled with some hot glue.
The plain Sensor is in the nut cover.

It's my primary outdoor sensor and i hadn't any outages since i installed it (5 months ago)

[makki]

For temperature-only you could use a usual connection-box (Klemmgehäuse, Spelsberg z.B.)

For humidity, the sensor isn't really spec'd for outside-use. Several issues with condension etc but some though use it in some weather-protected but open (on the bottom) box - myself included but without any warranty!

Makki

[martenss]

Looking to the replies I realized that I forgot 1 important word in my initial text: it concerns 1-Wire iButton probes...

Kind regards, martenss

[makki]

The probes are water-proof (on the outside) so take anything that looks nice to you, can house the cabling, isn't much thicker than 3mm and drill a 20mm hole into

For UP a "Blindabdeckung" and getting a 20mm drill bit might be an easy&clean way..

Makki