Dimmaktoren: 1-10V controller

[jef2000]

Any other suggestion ?

ABB AA/S 4.1, but it's expensive if you just need 1 output...
Berker 7531 30 05, same remark

Kr,

Jean-François

[jef2000]

I'm still puzzled
If I look at the schematic of the Walther ED 0103 I see connections A, B, V+, V-, L, N and EVG 1-10V. So I guess there are connections for the Bus, for the external power supply, Line, Neutral and the actual control voltage

This module is just a extension module for the Eiboxx central module. A, B, V+ and V- must be connected to the central module.

Kr,

Jean-François

[Warichet]

Thank you for your reply.

Normaly the EVG ("Vorschaltgeräte") generates the power supply for dimming with 1-10V-Interface.

I'm still puzzled
If I look at the schematic of the Walther ED 0103 I see connections A, B, V+, V-, L, N and EVG 1-10V. So I guess there are connections for the Bus, for the external power supply, Line, Neutral and the actual control voltage

On the other hand, If a take a Dimmaktor, i.e. Hager TK030, I see 3 inputs 1-10V, but no voltage supply. I guess I missed something here.
Thank you for putting me right.

Better, in my opinion, is of course DALI.

I'm convinced, simply no choice

Normaly the EVG ("Vorschaltgeräte") generates the power supply for dimming with 1-10V-Interface. In the Dimmactuator is a built-in variable resistor which make the "dimming".

So you can use every 1-10V-Actuator.

Better, in my opinion, is of course DALI.

[Warichet]

Hi,

I'm looking for a module generating 1-10V to control Dimmaktoren (Tridonic C001 or alike).

So far, I've only found the ED 0103 Schaltdimmermodul 1-fach from Walther Werke, but it needs an external supply of "19 V DC vom Zentralmodul"

Any other suggestion ?