X1 Garden lighting Logic control

[Clonganny]

Hi, Im new here and first time posting, so apologies if this question is in the wrong section or has been answered already.
Im using the Gira X1 for a logic problem I have.
I want to switch on 3 sets of garden lights A,B and C
These will only come on when:-

• The area is dark enough (Ive acvieved this using a twilight sensor to give me a 1 or 0)
• The garden gates have opened (Ive achieved this by taking a signal from the gate and running it through a Binary input module to give me a 1 or 0)
• And the Garden Lgihts "A" are already off (Ive taken the feedback from Switch actuator to give me a 1 or 0)

Ive input these through an "And" gate and when all inputs are satisfied I get a positive "1" output.
I then split this through 3 different on/Off delay Logic blocks to bring the different areas of the garden lighting on with slight time differences to make it more welcoming. This is where I run into problems. As gaden Lights "A" have now come on this sends an off signal into the "And" gate and the off sequence starts to activate.

Any help on this would be a great help.
Regards
Robbie
image.png

[knxPaul]

Try to implement the logic for garden Lights "A" with an additional AND gate without input "Gate open or closed".