Hello,
I am a complete beginner when it comes to KNX.
My installation consists of the following components:
Power supply: ABB S30.640.5.1 (640 mA)
IP interface: Schneider SpaceLogic MTN6502-0105
Switch: Schneider SpaceLogic MTN6705-0008S
I’d like to start by updating the Schneider devices using the “SpaceLogic KNX DFU Tool Secure (EN).”
That’s where I’m already running into trouble—it finds the IP interface, but I think I first need to configure something in ETS6 and assign addresses.
That’s not working, because I keep getting an error message when trying to download the switch.
Is there anyone who can help me get started via a paid video call?
And who has also used the Schneider DFU tool for firmware updates before?
I’m completely new to KNX, and I think I’m doing something wrong with the addresses in ETS6.
I am a complete beginner when it comes to KNX.
My installation consists of the following components:
Power supply: ABB S30.640.5.1 (640 mA)
IP interface: Schneider SpaceLogic MTN6502-0105
Switch: Schneider SpaceLogic MTN6705-0008S
I’d like to start by updating the Schneider devices using the “SpaceLogic KNX DFU Tool Secure (EN).”
That’s where I’m already running into trouble—it finds the IP interface, but I think I first need to configure something in ETS6 and assign addresses.
That’s not working, because I keep getting an error message when trying to download the switch.
Is there anyone who can help me get started via a paid video call?
And who has also used the Schneider DFU tool for firmware updates before?
I’m completely new to KNX, and I think I’m doing something wrong with the addresses in ETS6.