KNX/EIB ABB UK/S 32.2 practical experience

[Warichet]

Hi,

Someone has practical experience with the ABB UK/S 32.2 ?
I've read the doc, but can't find any info about the size of the wires to be used (0,6?, 0,8?) nor about how to remove a wire.
The doc on page 1 says

Plug-in screw terminals

but there are no screws

Thank you for any hint.

PS: maybe I don't have the right doc, I've a 49 page manual
UKS_322_PH_EN_V1-0_2CDC510066D0201.pdf

[makki]

Hmm, I only have two (much worse) UK/S 32.1 for several things (17x heating-actuators with Finder SSR, remainer is windows, Status LEDs etc.)
All with Xx0.6 Y(St)Y <100m if that answers your question..

Makki

[Warichet]

All with Xx0.6 Y(St)Y

Thank you for the reply.
Did you manage to remove a wire from the device ? or is it once for ever

[teichsta]

Did you manage to remove a wire from the device ? or is it once for ever

no it isn't ... there are (very small) screws.

[Warichet]

there are (very small) screws.

I removed the tomatoes from my eyes , but still can't see the screws.

Do I need to remove the green terminal bar to access the screws ?

Thank you

[teichsta]

the screws are hidden on the given picture. They appear if you pull out the "Steckerleisten".

[Warichet]

the screws are hidden on the given picture. They appear if you pull out the "Steckerleisten".

Thank you
Based on your information, I did pull-out the "Steckerleisten".
I'm very happy about ABB , but on a 50 page manual, there is not a word about this

[teichsta]

Thank you

you are welcome!