HomeServer and serial Interface

[Warichet]

Hi,

I understand that the KNX does not support the HS as an interface anymore (unless extra license).
I guess, that's true for the serial interface as well.
My config is:

HS <--serial cable-->Gira FT 1.2 <--KNX Bus-->

What would be the recommended way for the right solution ?

Thanks for any advice

[MatthiasS]

Buy an USB interface from GIRA.

[MatthiasS]

But you can use the HS as an programming device with ETS5 only by adding the extra licence for Eiblib/IP.

[Warichet]

Hi Matthias,

Nice to hear from you again :-)

Buy an USB interface from GIRA.

Thanks