Eibmarkt N401 settings within HS

[Warichet]

Hi,

My HS is connected to the bus via an FT1.2
I've bought an Eibmarkt N401 to replace the FT1.2.

So far, I've configured the N401 in ETS, it works fine, I can ping the N401 and I can program KNX devices. The busmonitor is OK.

I'm unable to make my HS work with the N401.
My project was set-up for a FT1.2, so I need to adapt the parameters under "EIB & iETS" but what should I put there ?
I see EIBnet/IP routing, but that's not the case
I changed the PA to put the new PA address

From the browser, when I try to switch on a lamp, nothing happens, it is as if there is no communication.

Thank you for any hint

[vento66]

Hi Raymond!

It looks bad, you need an IP Router like the Eibmarkt 402. The HS works only with IP Routing.

[Warichet]

you need an IP Router like the Eibmarkt 402. The HS works only with IP Routing.

Aargh, I should have known better
There are indeed plenty of posts about the topic, but didn't realize the impact.... until it's too late.

Nevertheless, thank you for the quick reply