Hello
I have been using the module (named Lufterst...) for last few years succesfully. (Thank you Mathias)
Since I dont speak/read german the use of the module is based on google translate. But I cannot implement it fully.
My setup -
HVAC control - Fan 3 stage(Its a ABB FCA), controlled by ABB solo). As you can see in attached pic the ETS points.
I thought that by sending "1" to address 2/1/1 will make fan speed 1, sending "1" to 2/1/2 will make fan speed 2 and sending "1" to 2/1/3 will make fan speed 3. I am able to test this by sending these bits to the bus directly. I am unable to do this using Mathias module. (I assumed that the quadclient module will do that).
Can you help me in setting this us properly.
Thank you.
nitin
I have been using the module (named Lufterst...) for last few years succesfully. (Thank you Mathias)
Since I dont speak/read german the use of the module is based on google translate. But I cannot implement it fully.
My setup -
HVAC control - Fan 3 stage(Its a ABB FCA), controlled by ABB solo). As you can see in attached pic the ETS points.
I thought that by sending "1" to address 2/1/1 will make fan speed 1, sending "1" to 2/1/2 will make fan speed 2 and sending "1" to 2/1/3 will make fan speed 3. I am able to test this by sending these bits to the bus directly. I am unable to do this using Mathias module. (I assumed that the quadclient module will do that).
Can you help me in setting this us properly.
Thank you.
nitin
Kommentar