KNX/EIB How can I do this?

[MikeMelga]

I have a Gira Led signal light 1171 00. It is basically an indicator light with two colors: red and green. They are both independently switchable.

I am using this to see my alarm state (armed or disarmed). Although I don't have my alarm fully programmed I use this to check if my 'pseudo alarm' is on or off (the pseudo alarm is just a connection to openremote that triggers a phone call everytime the KNX sensors pick up movement).

So... I've connected both color switches to a KNX actuator (one output per color).

I toggle the 'alarm' on and off via two pushbuttons: one turns it on, the other turns it off. Then I have openremote switching off the other color.

My problem is:

I now want to turn the alarm on and off via a Gira keyless in keypad. For that, I need to make the toggle work properly.

I already have the keyless in connected to a binary input but... how can I have it turn one light on and another off at the same time?

I also have an ABB LMS1.1 logic module if it helps.

Any suggestion?

Thanks.

Regards,
Mike

[vento66]

Configure one actuatorchannel as opener and one as closer. Trigger them withe the same GA.

[MikeMelga]

vento66,
Thanks for your answer.

Configure one actuatorchannel as opener and one as closer. Trigger them withe the same GA.

You lost me there
How can I do that?

[division]

One is normaly closed... the Light is on.
The other is normaly open... the Light is off.

Whenn you trigger both a the same Time by the same GA, they will change their state.

You can set this in the Actor Application in the ETS.

Regards

[MikeMelga]

division,

Got it! Thanks!

Will try that.

Thanks to you both.

Regards,
Mike