KNX/EIB Griesser MGX-9

[Guillaume]

Hello,

Sorry to post a message in English but my German is very limited...

I have successfully installed and programmed "basic" MGX-9 functions to control sunblinds from Griesser. However, I don't manage to do the following:

- Reuse local binary inputs (some of the commands are coming directly from the bus, and there are some binary inputs left over that I would like to re-use)

- I don't manage to find status group objects, providing the position and orientation of a sunblind.

That would be much appreciated if anyone with experience with MGX-9 programing could help me out with that...

THanks in advance.

Kind regards,

Guillaume.

[flippo]

Go to the parameters of the MGX-9, in the left above corner is a symbol you can click on to switch the parameters into the professionel mode.

Then you can see all the settings you need.

[Guillaume]

Thank you so much! THat's very helpful.

Cheers.

Go to the parameters of the MGX-9, in the left above corner is a symbol you can click on to switch the parameters into the professionel mode.

Then you can see all the settings you need.